Omaha Tactical LLC provides weapon parts coatings in two different forms.  Nikel Teflon and Cerakote finishes.  SEE BELOW FOR PRICING AND EXAMPLES

NICKEL TEFLON COATING

Nickel Teflon coating allows your weapon part  greater reliability  by providing a greater friction coefficient and reducing the overall wear your parts endure over extended use periods.  The coating also makes the weapon easier to clean.  The Teflon allows the user to simply just wipe many of the parts down with a rag and re-lubricate to fully clean the weapon.  After a long day on the range it’s very nice to simply take out your Teflon coated bolt carrier wipe it down and reinsert it. 

FRICTION / LUBRICITY

Nickel Teflon coatings provide very low frictional values far superior to conventional electroplated deposits. The wear resistance of nickel teflon is very good in applications where sliding wear is involved.   In non-lubricated wear applications, deposits of MICROLUBE can increase part life by reducing friction. the anti-stick properties of Nickel teflon are excellent, resulting in improved part quality and greatly reduced cycle times. Reductions of 20 - 35% are common.

CORROSION RESISTANCE

The corrosion protection afforded by this coating is enhanced by the high phosphorus content of the nickel matrix. At thicknesses of 0.5 to 1.0 mil, salt spray resistance of 500 to 1000 Hours per ASTM B 117 can be achieved.

 Nickel teflon coating is a unique electro less nickel composite plating process that co deposits Teflon (polytetrafluoroethylene) at 20 to 25% by volume as occluded particles in the plated coating. This chemical plating process is specially designed to produce a consistent amount of uniformly dispersed PTFE throughout the nickel matrix in order to insure optimum performance in high friction and non-lubricated applications. Components with complex shapes are especially well served since the process provides 100% coverage with no edge build-up! Typical coating thickness is .0002" - .0003" thick.

Omaha Tactical LLC is not a gun dealer and cannot accept lower receivers for coating procedures.  All parts other than barrels  and lower receivers are accepted.

coating/coating1.jpg
coating/coating05.jpg
coating/COATING13.jpg

coating/COATING34.jpg
coating/COATIN37.jpg
coating/COATIN39.jpg

coating/COATING64.jpg
coating/COATING61.jpg
coating/COATING63.jpg

coating/COATING22.jpg

Nickel Teflon Coating for Bolt Carrier group and Charging Handle
(Price $65.00)

Approximate turnaround time 3 weeks

coating/COATING21.jpg

Nickel Teflon Coating for Bolt Carrier Group (Price $60.00)

Approximate turnaround time 3 weeks

coating/COATING27.jpg

Nickel Teflon Coating for Charging Handle (Price $15.00)

Approximate turnaround time 3 weeks

coating/coating1.jpg

Nickel Teflon Coating for Stripped Upper Reciever (Price $95.00)

Approximate turnaround time 3 weeks

coating/COATING61.jpg

Nickel Teflon Coating for Handgun Slide (Price $115.00)

Approximate turnaround time 3 weeks